Mitsubishi Electric CR800 Series - Registering Current Position Data for SQ Direct

3 Description of functions
3-55
 Number of devices for bit access
This is the data required to specify the number of devices accessed in bit units.
• When performing data communication in ASCII code
Convert the number of devices to 2 ASCII code digits (hexadecimal), and send them in the order from higher-order
byte to lower-order byte. Use codes in upper case characters if specifying letters of the alphabet.
• When performing data communication in binary code
Convert the number of devices to hexadecimal and send.
20 devices
Example
Number of devices: 5 / 20
5 devices
20 devices
Example
Number of devices: 5 / 20
5 devices