Mitsubishi Electric FX3U-ENET-ADP - External Dimensions and Part Names; Pin Configuration

1 Introduction
1.2 External Dimensions and Part Names
16
FX3U-ENET-ADP User's Manual
1.2 External Dimensions and Part Names
1.3 Pin Configuration
The pin configuration of FX3U-ENET-ADP RJ45 type modular jack is as follows:
[1]
DIN rail mounting groove
(DIN rail: DIN46277, 35mm (1.38") width)
[6] Special adapter connector
[2] Nameplate [7] 10BASE-T/100BASE-TX connector (RJ45)
[3]
Direct mounting hole 2 holes of φ4.5 (0.18")
(mounting screw: M4 screw)
[8] External ground terminal (M2.5 terminal block screw)
[4] Status LEDs [9] DIN rail mounting hook
[5] Special adapter fixing hook
Pin No. Signal Direction Contents
1 TD+ Out + side of sending data
2 TD- Out - side of sending data
3 RD+ In + side of receiving data
4Not used-
5Not used-
6 RD- In - side of receiving data
7Not used-
8Not used-
[2]
Unit: mm(inches)
MASS(Weight): 0.1kg(0.22lbs)
[1]
90(3.55″)
106(4.18″)
23(0.91″)
20.5
(0.81″)
[7]
[6]
[9]
[8]
[5][4]
7(0.28″)
81.5(3.21″)
98(3.86″)
(mounting hole pitch)
[3]
81