8 The Operation of GX Works2
8.1 Ethernet adapter Setting
88
FX3U-ENET-ADP User's Manual
8. The Operation of GX Works2
This chapter explains operations of GX Works 2 related to the Ethernet adapter setting and others.
GX Works2 Ver. 1.73B and later supports the Ethernet adapter setting.
In order to set up the Ethernet adapter by GX Works2, FX Configurator-EN needs to be installed.
For operation of GX Works2, refer to the GX Works2 Version 1 Operating Manual (Common).
For descriptions of each function, refer to Chapter 6.
8.1 Ethernet adapter Setting
Set Ethernet adapter on the "Ethernet Adapter" tab of the "FX Parameter" screen.
Setting Description
Channel
Select whether or not the Ethernet adapter is connected. When it is connected, specify the channel
connected to the Ethernet adapter.
[Setting]
•Not Set
• CH1
• CH2
Input Format
Select the input format and display format used to set the IP address, subnet mask pattern and default
router IP address.
[Setting]
•Decimal
• Hexadecimal
IP Address
*1
Set the Ethernet adapter IP address.
[Setting range]
• 0.0.0.1 to 223.255.255.254 (Decimal)
• 00.00.00.01 to DF.FF.FF.FE (Hexadecimal)
To Next Page
Loading...
