Mitsubishi Electric FX3U-ENET-ADP - System Configuration

3 System Configuration
3.1 General Configuration
21
FX3U-ENET-ADP User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Introduction of Functions
7
Communication Using MC Protocol
8
The Operation of GX Works2
9
Troubleshooting
A
List of Special Devices
3. System Configuration
This section explains the system configurations that may be used with the Ethernet adapter.
3.1 General Configuration
Component list
*1. A hub is not used in direct connection (simple connection) etc.
*2. Time information server.
*3. Shielded twisted pair cable.
Part name Model name Remarks
Ethernet adapter FX3U-ENET-ADP
An expansion board is required to connect the FX3U-ENET-ADP
with the FX3U/FX3UC-32MT-LT(-2) PLCs.
PLC FX
3U/FX3UC PLC -
PC software GX Works2
PLC programming software.
This software writes various settings for the Ethernet adapter.
Personal computer - -
HUB
*1
- Use an industrial product.
SNTP server
*2
--
External device - MC protocol conforming device
Ethernet cable -
10BASE-T: Category 3 or better (STP cable
*3
)
100BASE-TX: Category 5 or better (STP cable
*3
)
FX3U/FX3UC PLC
MELSOFT connection
SNTP server
FX
3U-ENET-ADP
Connection of user application
and other company device
(MC protocol)
External device
(Client)
Maintenance
GX Works2, others
(MELSOFT connection)