Mitsubishi Electric FX3U-ENET-ADP - Setting Items List; Settings and Procedures Prior to Starting the Operation

6 Introduction of Functions
37
FX3U-ENET-ADP User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Introduction of Functions
7
Communication Using MC Protocol
8
The Operation of GX Works2
9
Troubleshooting
A
List of Special Devices
6.3 Setting Items List
6.3 Setting Items List
The table below shows parameter settings set in the Ethernet adapter.
: Setting is required when applicable function is used : Setting not required
6.4 Settings and Procedures Prior to Starting the Operation
Setting Description
Necessity of parameter setting
Reference
section
MC protocol MELSOFT
Channel
Select whether or not the Ethernet adapter is connected.
When the Ethernet adapter is connected, select the channel
(CH).
Section 8.1
Operation setting Set the common items in the Ethernet adapter.
Section 6.6,
Section 8.1
Open setting
Set the connection opening processing required to transfer
data with the external device.
Section 6.11,
Section 8.2
Procedures prior
to operation
Operation
Parameter setting of the Ethernet adapter is
performed.
For setting of the Ethernet adapter, refer to
Section 6.5 and Section 6.6.
Wiring
For wiring, refer to Chapter 5.
For installation, refer to Chapter 4.
Installation
For connection with PLC, refer to Section 3.4.
Ethernet adapter is connected to the PLC.
The PING command is sent from
an external device and completion of the initial
processing of the Ethernet adapter is checked.
For completed confirmation of the initial
processing, refer to Section 6.10.
Create a program for each communication
Refer to applicable communication function.