Mitsubishi Electric FX3U-ENET-ADP - Commands and Control Contents

7 Communication Using MC Protocol
82
FX3U-ENET-ADP User's Manual
7.6 Remote RUN/STOP, PLC model name code read
7.6 Remote RUN/STOP, PLC model name code read
This function is used to remotely RUN/STOP a PLC and read the model name of a PLC from an external
device.
7.6.1 Commands and control contents
This section describes the commands and control contents of the control procedure when controlling the
status of the PLC.
1) Commands
Function Command / Response type Processing
Remote RUN 13H
Requests remote RUN (execute operation)
Executes a forced RUN regardless of the RUN/STOP switch status of PLC.
Remote STOP 14H
Requests remote STOP (stop operation)
Executes a forced STOP regardless of the RUN/STOP switch status of PLC.
PLC model name read 15H Request to read the model name of the PLC.