Mitsubishi Electric MELSEC FX3U - Page 274

272
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
9 Move and Compare – FNC 10 to FNC 19
9.7 FNC 16 – FMOV / Fill Move
• When a constant (K) is specified as the transfer source , it is automatically converted into binary.
2. 32-bit operation (DFMOV and DFMOVP)
The contents of [ +1, ] are transferred to "n" 32-bit devices starting from [ +1, ].
• The contents will be the same among all of "n" 32-bit devices.
• If the number of points specified by "n" exceeds the device number range, data is transferred within the
possible range.
• While the command input is OFF, the transfer destination [ +1, ] does not change.
• While the command input is ON, the data of the transfer source [ +1, ] does not change.
• When a constant (K) is specified as the transfer source [ +1, ], it is automatically converted into
binary.
S
FNC 16
FMOV
n
S  D 
Command
input
+1
+2
+3
+4
n
S  D 
D 
D 
D 
D 
S S D D
D D
S S
S S
X000
FNC 16
DFMOV
n
S  D 
+1,
+1,
n
+3, +2
+5, +4
+7, +6
+9, +8
S  D 
D 
D 
D 
D 
S  D 
D 
D 
D 
D 