798
FX3G/
FX
3U
/FX
3UC
Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
34 FX3U-CF-ADP Applied Instructions – FNC300 to FNC305
34.5 FNC 304 – FLCMD / FX3U-CF-ADP command
34.5.1 Detailed explanation of setting data
Details of the setting data in the FLCMD instruction are as shown below.
*1. The CompactFlash
TM
card is available in the "mounted" status.
*2. The CompactFlash
TM
card is unavailable in the "unmounted" status.
Cautions
• It is not permitted to use an RS (FNC 80)/RS2 (FNC 87)/IVCK (FNC270)/IVDR (FNC271)/IVRD (FNC272)/
IVWR (FNC273)/IVBWR (FNC274) instruction and an FLCRT (FNC300)/FLDEL (FNC301)/
FLWR (FNC302)/FLRD (FNC303)/FLCMD (FNC304)/FLSTRD (FNC305) instruction for the same port.
Setting items Description Data Type
Contents of instruction for operation
K0 to K63 : Forcibly writes the buffered data of the specified file ID to the CompactFlash
TM
card.
K-1 : Forcibly writes all buffered data to the CompactFlash
TM
card.
K256(H100) : Sets the CompactFlash
TM
card to the mounted status
*1
.
K512(H200) : Sets the CompactFlash
TM
card to the unmounted status
*2
.
K1280(H500) : Clears error codes stored in the CF-ADP.
16-bit binary
n
Channel number used by the CF-ADP
K1 : ch1
K2 : ch2
16-bit binary
S
To Next Page
Loading...
