Mitsubishi Electric MELSEC FX3U - Appendix A-1-5 Cautions on Using Transparent (2-Port) Function of GOT-F900 Series

955
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
A Programming Tool Applicability and Version Upgrade History
A-1 Programming Tool Applicability
31
FNC275-FNC279 Data Transfer 3
32
FNC280-FNC289 High Speed Processing 2
33
FNC290-FNC299 Extension File Register
34
FNC300-FNC305 FX
3U
-CF-ADP
35
SFC•STL Programming
36
Interrupt Function
37
Special Device
38
Error Code
A
Version Up Information
B
Execution Times
Appendix A-1-5 Cautions on using transparent (2-port) function of
GOT-F900 Series
Make sure to provide the following setting when monitoring circuits, device registration, etc. in an FX3G/FX3U/
FX
3UC PLC using GX Developer Ver. 8.13P or later (Ver. 8.72A or later in an FX3G PLC) and the transparent
(2-port) function of the GOT-F900 Series.
If the following setting is not provided, monitoring cannot be normally executed .
*1. GX Developer Ver.8.13P or later supports the FX
3UC Series.
*2. GX Developer Ver.8.72A or later supports the FX
3G Series.
Setting in GX Developer Ver. 8.13P or later (Ver. 8.72A or later in FX3G PLC)
1. Select [Online] → [Transfer setup...] to open "Transfer Setup" dialog box.
2. Double-click [PLC module] in [PLC side I/F] to open [PLC side I/F Detailed setting of PLC
module] dialog box.
3. Put a check mark in the check box [via GOT-F900 transparent mode] as shown below.
4. Click [OK] button to finish the setting.
GX Developer
Ver.8.12N or earlier
*1
GX Developer
Ver.8.13P or later
GX Developer Ver.8.22Y or later
*2
When using
transparent function in
GOT-F900 Series
Setting shown below is
not required.
Setting shown below is
required.
Select "RS-232C" on "PC side I/F Serial
setting" dialog box, and execute settings
shown below.
When directly
connecting GX
Developer to PLC
(standard built-in RS-
422 port)
Set "COM port" and "Transmission speed" on "PC
side I/F Serial setting" dialog box.
Select "RS-232C" on "PC side I/F Serial
setting" dialog box, and set "COM port" and
"Transmission speed".
Double-click it.
Put a check mark in the
check box "via GOT-F900
transparent mode".