775
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
33 Extension File Register Control – FNC290 to FNC299
33.4 FNC293 – LOGR / Logging R and ER
31
FNC275-FNC279
Data
Transfer 3
32
FNC280-FNC289
High Speed
Processing 2
33
FNC290-FNC299
Extension File
Register
34
FNC300-FNC305
FX
3U
-CF-ADP
35
SFC•STL
Programming
36
Interrupt
Function
37
Special Device
38
Error Code
A
Version Up
Information
B
Execution Times
4)Change the current program inside the PLC to the program shown in “Cautions on using a memory
cassette” in “Cautions” on the previous page.
5)To the PLC, write the data which was temporarily withdrawn to GX Developer.
[1]Select “Online” → “Write to PLC...” to
display the “Write to PLC” window.
[2]Click “PLC parameter” and “MAIN” to put
a check mark to each of them.
[3]Click [Execute] button to execute writing.
*2.For Ver. 8.13P to 8.24A of GX Developer, the PLC
type is FX
3UC.
6)Change the PLC mode from STOP to RUN, execute the program, and store the data to the extension file
registers inside the memory cassette.
FX3U(C)*2
To Next Page
Loading...
