Mitsubishi Electric MELSEC FX3U - Page 894

892
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
37 Operation of Special Devices (M8000 -, D8000 -)
37.1 Special Device List (M8000 -, D8000 -)
Input Filter
D 8020
Input filter
adjustment
Input filter value of X000 to X017
*1
(Default: 10 ms)
→Refer to Subsection 37.2.9.
3 3 3 – 3333 3
[D]8021
Not used
– – – – –––– –
[D]8022
– – – – –––– –
[D]8023
– – – – –––– –
[D]8024
– – – – –––– –
[D]8025
– – – – –––– –
[D]8026
– – – – –––– –
[D]8027
– – – – –––– –
Index Register Z0 and V0
[D]8028
Value of Z0 (Z) register
*2
3 3 3 – 3333 3
[D]8029
Value of V0 (V) register
*2
3 3 3 – 3333 3
*1. In FX3G, FX1N, FX1NC PLCs the input filter can be adjusted in X000 to X007.
In FX
3U, FX3UC, FX2N, FX2NC PLCs (16 points type) the input filter can be adjusted X000 to X007.
*2. The values of Z1 to Z7 and V1 to V7 are stored in D8182 to D8195.
Analog Volume [FX3G, FX1S, FX1N]
[D]8030 Value of analog volume VR1 (Integer from 0 to 255)
3 – ––33 –––
[D]8031 Value of analog volume VR2 (Integer from 0 to 255)
3 – ––33 –––
Constant Scan
[D]8032
Not used
– – – – –––– –
[D]8033
– – – – –––– –
[D]8034
– – – – –––– –
[D]8035
– – – – –––– –
[D]8036
– – – – –––– –
[D]8037
– – – – –––– –
[D]8038
– – – – –––– –
D 8039
Constant scan
duration
Default: 0 ms (in 1 ms steps)
(Writes from system ROM at power ON)
Can be overwritten by program
→Refer to Subsection 37.2.15.
3 3 3 M8039 333 3 3
Number and name Content of register
Applicable model
FX 3G FX 3U FX 3UC
Correspond-
ing special
device
FX 1S FX 1N FX 2N FX 1NC FX 2NC