3 SIGNALS AND WIRING
3.5 Signal (device) explanation
79
3
Output device explanation [G] [WG]
■MBR (Electromagnetic brake interlock)
MBR is off in the servo-off state or at an alarm occurrence.
If using the device, set an operation delay time of the electromagnetic brake in [Pr. PC02].
For details. refer to "Electromagnetic brake interlock function" in the following manual.
MR-J5 User's Manual (Function)
■VLC (Limiting speed)
If the speed reaches the speed limit value in the torque mode, VLC will turn on. VLC will turn off in the servo-off state.
The device cannot be used in the position mode or the velocity mode.
■ZSP (Zero speed detection)
If the servo motor speed is the zero speed or less, ZSP will turn on. The zero speed can be changed with [Pr. PC07]. The
following shows an example when the initial value (50) is set in [Pr. PC07].
ZSP will turn on when the servo motor speed is reduced to 50 r/min (at (1)), and will turn off when the servo motor is increased
to 70 r/min again (at (2)).
ZSP will turn on when the servo motor is decelerated again to 50 r/min (at (3)), and will turn off when the servo motor speed
reaches -70 r/min (at (4)).
The range from the point when the servo motor speed has reached the on-level and ZSP turns on, to the point when the
speed has increased again and reached the off-level is called a hysteresis width.
The hysteresis width is 20 r/min for this servo amplifier.
If using a linear servo motor, replace [r/min] with [mm/s].
■TLC (Limiting torque)
If the torque reaches the torque limit value when torque is generated, TLC will turn on. TLC will turn off in the servo-off state.
In the torque mode, TLC is off.
OFF
ON
20 r/min
[Pr. PC07]
20 r/min
-70 r/min
-50 r/min
50 r/min
70 r/min
0 r/min
[Pr. PC07]
ZSP
(1)
(2)
(4)
(3)OFF level
Forward
rotation
direction
(Hysteresis width)
ON level
Servo motor
speed
ON level
Reverse
rotation
direction
(Hysteresis width)
OFF level
(Zero speed detection)
To Next Page
Loading...
