22
1 INTRODUCTION
1.3 Wiring check
1.3 Wiring check
Before switching on the main circuit and control circuit power supplies, check the following items.
Power supply system wiring
Power supply system wiring
• Check that the power supplied to the power input terminals (L1/L2/L3/L11/L21) of the servo amplifier satisfies the defined
specifications. For the power supply specifications, refer to "Servo amplifier standard specifications" in User's Manual
(Introduction).
• If the power factor improving DC reactor is not used, check that P3 and P4 are connected.
To Next Page
Loading...
