6 INSTALLATION AND WIRING
6.2 Setting Switch
117
6
6.2 Setting Switch
Indicator cover of the I/O module (waterproof module)
To operate the setting switches of the I/O module (waterproof module), loosen the screws for the indicator cover with the
screwdriver and open the cover. After finishing the operation, be sure to close the indicator cover and tighten the screws.
When the cover is open or the screws have not been tightened properly, waterproof performance is lost.
Tightening torque
Tighten the screws for the indicator cover within the following tightening torque range.
• Do not put oil on the screws. Doing so may damage the screws.
• Tighten the screws with an applicable screwdriver. Tightening with an inapplicable screwdriver may damage
the screws.
Screw type Tightening torque range
Indicator cover screw (M3 screw) 0.43 to 0.57Nm
To Next Page
Loading...
