Mitsubishi Electric NZ2GN2S1-16D - Wiring of 40-Pin Connector

6 INSTALLATION AND WIRING
6.9 Wiring of I/O Module and External Device
141
6
Wiring of 40-pin connector
Tightening torque
Tighten the connector screws within the following tightening torque range.
Undertightening can cause short circuit, fire, or malfunction. Overtightening can damage the screw and/or module, resulting in
drop, short circuit, fire, or malfunction.
Applicable connector
Prepare 40-pin connectors separately.
The following tables list the types of connectors and reference products of crimping tools and pressure-displacement tools.
■40-pin connector
*1 When using 40 pins, use cables whose sheath outside diameters are 1.3mm or shorter. Select cables according to the amount of current
to flow.
■40-pin connector crimping tool and pressure-displacement tool
For how to wire the connectors and how to use the crimping tool and pressure-displacement tools, contact FUJITSU
COMPONENT LIMITED.
Signal name and wiring
For the signal names of the terminal block and wiring of the external device, refer to the specifications of each module. (
Page 22 Performance Specifications)
Incorrect wiring can cause malfunction of or damage on the module.
Screw type Tightening torque range
Connector screw (M2.6 screw) 0.20 to 0.29Nm
Type Model Applicable wire size
Soldering type connector (straight type) A6CON1
*1
0.08 to 0.3 (28 to 22 AWG), (stranded wire)
Crimping type connector (straight type) A6CON2 0.08 to 0.24 (28 to 24 AWG), (stranded wire)
IDC type connector (straight type) A6CON3 0.08 (28 AWG) (stranded wire)
0.25mm (30 AWG) (solid wire)
Flat cable (intervals of 1.27mm)
Soldering type connector (dual purpose (straight/oblique) type) A6CON4
*1
0.08 to 0.3 (28 to 22 AWG), (stranded wire)
Type Model Contact
Crimping tool FCN-363T-T005/H FUJITSU COMPONENT LIMITED
Pressure-displacement
tool
FCN-367T-T012/H (locator plate)
FCN-707T-T001/H (cable cutter)
FCN-707T-T101/H (hand press)