Mitsubishi Electric NZ2GN2S1-16D - Chapter 7 Parameter Setting; Network Configuration Setting

7 PARAMETER SETTING
7.1 Network Configuration Setting
151
7
7 PARAMETER SETTING
7.1 Network Configuration Setting
Set the parameters of the I/O module with the network parameters written to the CPU module of the master station.
For the setting procedure for the master station, refer to the following.
User's manual for the master station used
Communication cycle interval setting
When using the I/O module in CC-Link IE TSN, set the communication cycle interval setting as follows.
■For the I/O module with the firmware version of "03" or later
*1 Set with function setting switch 10. ( Page 120 Function setting switch setting)
*2 To use the I/O module in this combination, set the low speed in the multi-cycle settings of the master station to "x16", and set the
communication cycle setting of the I/O module to "Low-Speed".
*3 To use the I/O module in this combination, do not set the communication cycle setting of the I/O module to "Low-Speed".
■For the I/O module with the firmware version of "02"
*1 Set with function setting switch 10. ( Page 120 Function setting switch setting)
*2 To use the I/O module in this combination, set the low speed in the multi-cycle settings of the master station to "x16", and set the
communication cycle setting of the I/O module to "Low-Speed".
*3 To use the I/O module in this combination, do not set the communication cycle setting of the I/O module to "Low-Speed".
■For the I/O module with the firmware version of "01"
Communication speed Value that can be set
Master station I/O module
*1
1Gbps 1Gbps • When the value is set in increments of 1s: 125.00s or more and 10000.00s or less
• When the value is not set in increments of 1s: 31.25s, 62.50s, 125.00s, 250.00s, 500.00s,
1000.00s, 2000.00s, 4000.00s, or 8000.00s
100Mbps
*2
• When the value is set in increments of 1s: 125.00s or more and 625.00s or less
• When the value is not set in increments of 1s: 125.00s, 250.00s, or 500.00s
100Mbps 1Gbps • When the value is set in increments of 1s: 125.00s or more and 10000.00s or less
• When the value is not set in increments of 1s: 31.25s, 62.50s, 125.00s, 250.00s, 500.00s,
1000.00s, 2000.00s, 4000.00s, or 8000.00s
100Mbps
*3
• When the value is set in increments of 1s: 500.00s or more, 10000.00s or less, and divisible by 2s
• When the value is not set in increments of 1s: 500.00s, 1000.00s, 2000.00s, 4000.00s, or
8000.00s
Communication speed Value that can be set
Master station I/O module
*1
1Gbps 1Gbps • When the value is set in increments of 1s: 125.00s or more and 8000.00s or less
• When the value is not set in increments of 1s: 31.25s, 62.50s, 125.00s, 250.00s, 500.00s,
1000.00s, 2000.00s, 4000.00s, or 8000.00s
100Mbps
*2
• When the value is set in increments of 1s: 125.00s or more and 500.00s or less
• When the value is not set in increments of 1s: 125.00s, 250.00s, or 500.00s
100Mbps 1Gbps • When the value is set in increments of 1s: 125.00s or more and 8000.00s or less
• When the value is not set in increments of 1s: 31.25s, 62.50s, 125.00s, 250.00s, 500.00s,
1000.00s, 2000.00s, 4000.00s, or 8000.00s
100Mbps
*3
• When the value is set in increments of 1s: 500.00s or more, 8000.00s or less, and divisible by 2s
• When the value is not set in increments of 1s: 500.00s, 1000.00s, 2000.00s, 4000.00s, or
8000.00s
Item Value that can be set
Communication cycle interval setting (Not set in units of 1s) 125.00s or more and 8000.00s or less
Communication cycle interval setting (Set in units of 1s)