192
11 TROUBLESHOOTING
11.1 CC-Link IE TSN/CC-Link IE Field Diagnostics
11 TROUBLESHOOTING
This chapter describes error contents that may occur while the I/O module is used and those troubleshooting.
11.1 CC-Link IE TSN/CC-Link IE Field Diagnostics
For CC-Link IE TSN, monitor the status and conduct an operation test.
For details on CC-Link IE TSN/CC-Link IE Field diagnostics, refer to the following.
User's manual for the master station used
Remote reset
Perform the following operation to remotely reset a selected I/O module.
1. Select a slave station to be reset and click the [Remote Operation] button.
2. Follow the on-screen instructions and click the [Yes] button.
3. Follow the on-screen instructions and click the [OK] button.
■Remote reset
Remote reset of an I/O module may cause the following because it affects communications on another station.
• Another station is disconnected.
• A synchronous communication error 1 (error code: 0102H) occurs on another I/O module using the CC-Link IE TSN
Network synchronous communication function.
■Setting of function setting switches
When remote reset is performed, if the setting of either of the following function setting switches is different from the setting at
power-on, a Remote reset disable error (error code: 0270H) occurs, and the I/O module is not reset.
• Function setting switch 1
• Function setting switch 10
To Next Page
Loading...
