2 PART NAMES
17
2
• Waterproof/dustproof connector type
No. Name Application
(1) PW LED Indicates the power supply status of the I/O module.
On: Power supply ON
Off: Power supply OFF
RUN LED Indicates the operating status of the I/O module.
On: Operating normally.
Flashing: Operating in unit test mode
Off: A major error has occurred.
ERR. LED Indicates the error status of the I/O module.
On: A moderate error or major error has occurred.
Flashing: A minor error has occurred.
Off: Operating normally.
P1 LINK LED Indicates the link status for P1.
On: Link-up
Off: Linkdown in progress
P2 LINK LED Indicates the link status for P2.
On: Link-up
Off: Linkdown in progress
DATA LINK LED Indicates the data link status of the I/O module.
On: Cyclic transmission being performed
Flashing: Cyclic transmission stopped
Off: Disconnected
(2) IP address/station number
setting switch
Sets the fourth octet of the IP address.
Page 118 Setting the IP address/station number setting switches
(3) Function setting switch Sets functions of the I/O module.
Page 120 Function setting switch setting
(4) ■16-point module
X0 LED to XF LED
■32-point module
X0 LED to X1F LED
Indicates the ON/OFF status of the inputs.
*1
On: Input ON
Off: Input OFF
■16-point module
Y0 LED to YF LED
■32-point module
Y0 LED to Y1F LED
Indicates the ON/OFF status of the outputs.
*2
On: Output ON
Off: Output OFF
(5) I/O PW LED Indicates the status of the power supply from the external power supply.
On: External power supply ON
Off: External power supply OFF
(13)
(12)
(4)
(5)
(2)
(10)
(6)
(3)
(11)
(1)
(14)
To Next Page
Loading...
