188
9 PROGRAMMING
9.2 Program Example
4. Display "CC-Link IE TSN Configuration" window and configure the settings as follows.
[Navigation window] [Parameter] [Module Information] Model [Basic Settings] [Network Configuration
Settings]
5. Select [Close with Reflecting the Setting] and close the "CC-Link IE TSN Configuration" window.
6. Display the refresh parameter setting window and configure the setting as follows.
[Navigation window] [Parameter] [Module Information] Model [Basic Settings] [Refresh Settings]
7. Click the [Apply] button.
8. Write the set parameters to the CPU module of the master station and reset the CPU module of the master station, or
turn off and on the power supply of the programmable controller.
[Online] [Write to PLC]
9. Set the CPU module of the master station to RUN, and check that the DATA LINK LED of the I/O module is turned on.
To Next Page
Loading...
