─
10
─
1
Tap the Change ap direction button on the TOP screen.
When an FDK with a left/right ap is not connected:
☞
2
When one or more FDKs with a left/right ap are connected:
☞
3
■
If all the connected IUs are duct connected units,
the Change ap direction button will not be displayed.
Change ap direction
Change ap direction
Ind. ap
Control
Auto swing
Back
OutdoorRoomR/C
Select the ap direction.
2
When the Change set temp screen is displayed, select the
temperature as desired with using
▲ ▼ buttons.
3
After selecting the set temp, tap the Set button. The display
returns to the TOP screen.
■
For allowable temperature setting ranges, refer to the range setting of set temp
(
☞
page 57).
■
Reference set temp
Cooling … 26 to 28°C
Dry … 24 to 26°C
Heating … 20 to 24°C
Fan … Setting temp is not required.
■
If the
Auto is selected for the set temp, the set temp display shows “0”.
Temperature can be adjusted higher or lower with using
▲
▼ buttons. Note
that
Auto is not displayed and cannot be set when SC-SL2, SC-SL3, or SC-SL4
is connected.
■
If the
Back button is tapped without tapping the Set button, the selected
set temp is invalidated and the display returns to the TOP screen.
Change set temp
Auto
Set
Back
OutdoorRoomR/C
Tap
▲▼
to set temp & tap [Set].
2
When the Change ap direction screen is displayed, tap the button
of desired ap direction.
To swing the ap, tap the
Auto swing button.
To x the ap position, tap one of
1 to 4 buttons.
After selecting the ap direction,
When an FDK with a left/ right ap is not connected, the display
returns to the TOP screen. (
☞
1)
When an FDK with a left/right ap is connected, the display returns
to the Select ap screen. (
☞
3)
• If Power control for Motion sensor control is set to Enable, a temperature different from
the set temperature may be displayed. (
☞
page 27)
Advice
To Next Page
Loading...
