Start-I.ring Gove..--housing
Oil-_
Governor
..
ccwer
Fig.
1
connected with the eye
of
the pin which
is
inserted
in
the governor-housing. The pin
to
which the guide-lever
is
attached like a bob holds also the tension-lever likewise.
When
the
strong governor-spring contacted with the eye of the short
rim
of tension-lever
is
strained,
the tension-lever
is
pushed
to
the shifter and the governor-spring
is
streched until the
centrifugal force yielded by the rotation of engine balances with the spring force.
In
case
when the spring force
is
stronger than the centrifugal force
of
the flyweight, the
tension-lever
will
move until its lower end contacts with the adjustable fu!I-load stopper.
The revolving axis
of
the swivel-lever
is
inserted
in
the governor-bush, and the center of
the lever
is
slightly eccentric against the spring-eye of the tension-lever.
The other end
of
the governor-spring
is
connected with the knuckle which
is
attached
to
the upper end
of
the boat-shaped swivel-lever. There are two bosses on the side of the
boat-shape which will touch with the side of guide-lever when the engine
is
stopped so as
to
complete their work. The control-lever of the governor
is
attached
to
either side (left or
right) of the shaft
of
the swivel-lever according
to
the order.
Along with the rotation of the control-lever, the
swivel
lever
will
begin
to
revolve, and
-
35-
To Next Page
Loading...
