7-1 Cylinder head clamp bolts
Every 500Hr
of
run, re-screw head clamp bolts. For this, unfasten rocker case
cover, rocker ass'y and intake manifold, and screw them
to
specified clamping
torques
following
the
order indicated in Fig. 3-43.
Remember
that
it
must
be placed
with
apron-shaped
parts up.
In
clamping, screw
bolts first a little
but
un
i-
formly,
then
tight
according
to
the
illustration.
14
12
o 0
2
10
11
o 0
Notes: 1) Numbers show
bolt
screwing
order
2)
Camping
torque: 12.0 kg.m (861b-ft)
Fig. 3-43 Order
to
screw
bolt
on cylinder head
7-2 Main Bearing caps and
connecting rod caps
Each time
to
wash
oil
pan and strainer, check bolts on main bearing caps and
connecting rod
caps, and
if
loose, screw them tight again.
7-3
Others
Keep
the
following bolts and nuts tight.
Oil pan clamp bolts
Engine mounting bracket nuts
Engine mounting bolts
Exhaust manifold (outletl nuts
-
56-
To Next Page
Loading...
