1. Displays the [Station Number Switching] window.
2. Displays the station number and name for monitoring.
3. Displays the output frequency with a panel meter and a numerical display.
4. Sets the speed and rotation direction for operation.
（1） Touch [Low Speed], [Middle Speed] or [High Speed]. Then, touch [Forward] or [Reverse].
The inverter will operate at the respective speed pre-set with the parameters.
Touch [Stop] to stop the inverter operation.
（2） Set the speed directly by inputting a numeric value. Then, touch [Forward] or [Reverse].
The touch switches to the left and right of the value input area will increment or decrement the
running frequency by 1Hz.
Touch [Stop] to stop the inverter operation.
5. Displays the output current with a panel meter and a numerical display.
6. Displays inverter status with lamps.
Stop/Forward/Reverse : The rotation direction status is indicated with a light.
Inverter Running : Lights while the inverter is running.
Up to Frequency : Lights when the output frequency reaches the set frequency.
Frequency Detection : Lights when the output frequency is detected.
Instantaneous Power Failure : Lights during an instantaneous power failure.
Overload : Lights while the stall prevention function is activated.
Inverter Alarm : Turns on when an alarm is occurring.
7. Switches between the screens. The blue switch that indicates the currently displayed screen does not
switch the screen.
8. Switches to the previously opened screen.
9. Displays the current date and time. Touch the date and time to open the [Clock Setting] window.
10. Opens the [Language Setting] window.
To Next Page
Loading...
