Mitsubishi LE-40MTB-E - 4 Basics of Adjustment and Operation; Adjustment Flow for Trial Operation; Initial Setting

8
4.1 Adjustment flow for trial operation
Carry out the following start-up adjustment as the preparatory step for the automatic operation.
4.2 Initial setting
Select the items using the and keys.
Press the [Enter] key to finalize the setting.
Then, switch the screens using the and keys.
When the setting of the items marked with "" is not changed,
switch the screens using the and keys without press-
ing the [Enter] key.
Check by automatic
operation
Operational check
(1) (2)
(5)
(4)
(6)
(7)
(3)
Controller
* Initial setting
* Adjust tension detectors
Check the driving
system in manual
operation mode
Controller
installation and
wiring
Operating parameter
adjustment as necessary
See page 26 and after.
Completion of
adjustment
Check for abnormalities when
error occurs.
See pages 75 through 77.
See pages 8 through 10.
W X
T
S
T S
Power ON
P S S W . E N T .
S E T → # # # # E N T E R P A S S W O R D#
A
T S N . U N I T S E L E C T T E N T I O N U N I T
 × 10 N :  N
N
T
S A R T T H E I N I T I A L
O R C H A N G E T O M
T
When the power is turned on, the version display screen appears for a few seconds.
The password "4095" is originally registered. When a password other
than this is used, enter the new password on the "Password registration"
screen and press the [Enter] key to register it. Both the newly registered
password and the original value "4095" are valid.
T
T
L - 4 0 M T B - T e n s i o n C o n t r o l l e rE V e r . V # . # #
C o p y r i g h t M I T S U B I S H I E L E C T R I C C O R P .
E
4. Basics of adjustment and operation