16
5.4 Display of operator screen
The usual operations (setting operations) are performed on the following screen.
The values ara changed and valid by the pulser dial.
Note that in the screen shown MENU1 ~ MENU 7, the values changed will not be protected against power
supply interruption. To protect the set values against power supply interruption, press the [ENTER] key twice
to register the values in the menu table.
O U T P U T → # # # %
M N U . S E T
S E T → # # # %
A
T N S N . → # # # . # × 10 N
M N U . S E T
S E T → # # # %
A
Automatic
Operation
Mode selected
Tension set
• The bar graph in the upper right corner always
indicates the detected tension (%). The "100%"
indication corresponds to the full -scale tension.
• This is to enter the stall
values .
Refer to pages 13 and 14
for more about the stall
functions.
ST
Manual
Operation
Mode selected
ST
• This displays the set
tension.
• The unit of tension such
as "×10N" and " N " and
the position of the
decimal point are
determined depending on
the parameter setting .
When new reel and taper
functions are in use .
Manual setting
Total tension monitor
ST
ST
ST
Password
screen
• Sets the operation torque
for the manual operation .
Refer to page 15 for the
guideline of setting .
• Displays the tension or
the output by the
tension/output select
switch on the panel.
• When carrying out the
taper control , the taper
ratio is taken into the
"target (target tension )"
value.
• This displays the left and
right tension
measurement . This
allows to check whether
the tension in the material
is balanced.
When use reel diameter input ,
connected to LE -40MD,
“LINK” is selected in “TPR.DIA” screen.
T N S N . → # # # # N
M N U . S E T M E N U #
S E T → # # # %
A
T S N . M N T . L E F T → # # # . # × 10 N
R I G H T → # # # . # × 10 N
N
T A R G E T → # # # . # × 10 N
T S N . M N T .
T A R G E T → # # # . # × 10 N →
N
T S N . S E T M N T . →
S E T → # # # . # × 10 N →
N
S A L L S E T
S E T → # # # % O U T P U T → # # # %
T
S A L L S E T M E N U #
S E T → # # # % T N S N . → # # # # N
T
Stall set
T S N . S E T M E N U # M N T . →
S E T → # # # # N →
N
Tension monitor left and right
T S N . M N T . L E F T → # # # # N
R I G H T → # # # # N
N
T A R G E T → # # # # N
T S N . M N T .
T A R G E T → # # # # N →
N
To Next Page
Loading...
