5. Spindle Adjustment
5 - 10
bitE. In position loop in-position (INP)
During position loop control, this signal turns ON if the position droop drops below the value set
with SP153 (CINP) during C-axis control, SP185 (SINP) during spindle synchronous control, and
SP217 (TINP) during synchronous tap control.
bitF. Limiting current (CL)
This signal turns ON if a load higher than the spindle's excessive load withstand level is applied
during spindle motor rotation. This may also turn ON during motor acceleration/deceleration.
(2) Spindle control output 2
Spindle control output 2 is not used.
Name Details
Spindle control output 2
F E D C B A 9 8 7 6 5 4 3 2 1 0
bit Details
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
To Next Page
Loading...
