Mitsubishi MELDAS MDS-C1 - Connecting the Synchronous Control System

2. Wiring and Connection
2 - 19
2-4-3 Connecting the synchronous control system
The methods of connecting the synchronous control system are explained in this section. Explanations
on connecting the motor detector and power are omitted. Refer to section 2-4-1 Connecting the
servomotor for details.
Semi-closed system Full-closed system
Position command
synchronous control
The operation is controlled with position commands from the NC, so there are
no special connections.
(1) When using MDS-C1-V1
drive unit
MDS-C1-V1 drive unit
(3-1) When using serial output linear scale
(3-2) When using analog output linear
scale
(3-3) When using MP scale
Speed command
synchronous control
Current command
synchronous control
(2) When using MDS-C1-V2
drive unit
MDS-C1-V2 drive unit
(4-1) When using serial output linear scale
(4-2) When using analog output linear
scale