Mitsubishi Outlander 2007 - Page 114

Seat and seat belts
2-35
2
3-point type seat belt (with emergency locking
mechanism)
E00404900480
This type of belt requires no length adjustment. Once worn, the
belt adjusts itself to the movement of wearer, but in the event of
a sudden or strong shock, the belt automatically locks to hold
the wearer’s body.
To fasten
1. Pull the seat belt out slowly while holding the latch plate.
N
OTE
● When the seat belts cannot be pulled out in a locked con-
dition, pull the belts once forcefully and then return them.
After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a “click” is
heard.
3. Pull the belt slightly to adjust slackness as desired.
To unfasten
Hold the latch plate and push the button on the buckle.
N
OTE
● As the belt retracts automatically, keep the latch plate held
while retracting so that the belt stows slowly. Failure to do
this could damage the vehicle.
WARNING
!
● Never wear the lap portion of the belt across your
abdomen. During accidents it can press sharply
against abdomen and increase the risk of injury.
● The seat belts must not be twisted when worn.