2-36
Seat and seat belts
2
Driver’s seat belt warning lamp and display
E00409800354
A tone and warning lamp are used to remind the driver to fas-
ten the seat belt.
If the ignition switch is turned “ON” while a seat belt is not
worn, the warning lamp flashes and the tone sounds for about 6
seconds to remind the driver to fasten the seat belt.
If the vehicle is driven without fastening the seat belt, approxi-
mately 1 minute after the ignition switch is turned to the “ON”
position, the warning lamp goes on and flashes repeatedly, and
the tone sounds continuously. At the same time, “FASTEN
SEAT BELT” is displayed on the information screen in the
multi-information display.
The warning lamp goes off and the tone sounds stops after
approximately 90 seconds.
Subsequently, if the seat belt is still not fastened, the warning
lamp and tone will be activated to remind the driver to fasten
the seat belt whenever the vehicle is stopped and started off
again. The warning will operate in the same way if the seat belt
is removed while driving the vehicle. The warning will stop
when the seat belt is fastened.
To Next Page
Loading...
