EasyManua.ls Logo

Mitsubishi Outlander 2007 - Page 167

Mitsubishi Outlander 2007
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-16
Instruments and controls
3
Average speed display
E00521600018
This displays the average speed from the last
reset to the present time.
There are the following 2 mode settings.
For the method for changing the average speed
display setting, refer to “Changing the function
settings (when the ignition switch is “ON”)” on
page 3-27.
Manual reset mode
When the average speed is being displayed,
if you hold down the multi-information
meter switch, the average speed displayed
at that time is reset.
When the ignition switch is switched from
“ACC” or “LOCK” to “ON”, the mode set-
ting is automatically switched from manual
to auto.
Auto reset mode
When the average speed is being displayed,
if you hold down the multi-information
meter switch, the average speed displayed
at that time is reset.
If the ignition switch is at “ACC” or
“LOCK” for about 4 hours or longer, the
average speed display is automatically
reset.
NOTE
“---” is displayed when the average speed
cannot be measured.
The initial (default) setting is “Auto reset
mode”.
The display setting can be changed to the
preferred units (km/h or mph).
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on
page 3-27.
The memory of the manual reset mode or
auto reset mode for the average speed dis-
play is erased if the battery is disconnected.

Table of Contents

Related product manuals