Instruments and controls
3-17
3
Average fuel consumption display
E00521700019
This displays the average fuel consumption from
the last reset to the present time.
There are the following 2 mode settings.
For information on how to change the average
fuel consumption display setting, refer to
“Changing the function settings (when the igni-
tion switch is “ON”)” on page 3-27.
Manual reset mode
● When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, the average
fuel consumption displayed at that time is
reset.
● When the ignition switch is switched from
“ACC” or “LOCK” to “ON”, the mode set-
ting is automatically switched from manual
to auto.
Auto reset mode
● When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, the average
fuel consumption displayed at that time is
reset.
● If the ignition switch is at “ACC” or
“LOCK” for about 4 hours or longer, the
average fuel consumption display is auto-
matically reset.
NOTE
● “---” is displayed when the average fuel
consumption cannot be measured.
● The initial (default) setting is “Auto reset
mode”.
● The average fuel consumption will depend
on the driving conditions (road conditions,
how you drive, etc.). The displayed fuel
consumption may vary from the actual fuel
consumption. Treat the fuel consumption
displayed as just a rough guideline.
● The memory of the manual reset mode or
auto reset mode for the average fuel con-
sumption display is erased if the battery is
disconnected.
● The display setting can be changed to the
preferred units {km/L, mpg (US), mpg
(UK) or L/100 km}.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on
page 3-27.
To Next Page
Loading...
