EasyManua.ls Logo

Mitsubishi Outlander 2007 - Page 220

Mitsubishi Outlander 2007
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruments and controls
3-69
3
Headlamp washer switch*
E00507800146
The headlamp washer can be operated with the ignition switch
in the “ON” or “ACC” position and the lamp switch at the
” position.
Push the button once and the washer fluid will be sprayed on to
the headlamps.
N
OTE
If the ignition switch is in the “ON” or “ACC” position
and the headlamps are on, the headlamp washer operates
together with the windscreen washer the first time the
windscreen washer lever is pulled.
Check the headlamp washers periodically to confirm that
the washer fluid is being sprayed properly on to the head-
lamp lenses.
Precautions to observe when using wipers and
washers
E00510000025
If the moving wipers become blocked by ice or other
deposits on the glass, the motor may burn out even if the
wiper switch is turned to OFF. If obstruction occurs, park
your vehicle in a safe place, turn off the ignition, and
clean the deposits from the glass so that the wipers operate
smoothly.
Do not use the wipers when the glass is dry.
They may scratch the glass surface and the blades wear
out prematurely.
Before using the wipers in cold weather, check that the
wiper blades are not frozen onto the glass. The motor may
burn out if the wipers are used with the blades frozen onto
the glass.
Avoid using the washer continuously for more than 20
seconds. Do not operate the washer when the fluid reser-
voir is empty.
Otherwise, the motor may burn out.
Periodically check the level of washer fluid in the reser-
voir and refill if required.
During cold weather, add a recommended washer solution
that will not freeze in the washer reservoir. Failure to do
so could result in loss of washer function and frost dam-
age to the system components.

Table of Contents

Related product manuals