OTE
● After pushing the “SONAR” switch, reversing sensor sys-
tem operation differs according to the detection area set-
ting.
• Setting when towbar is not equipped
When the gearshift lever is moved to the “R” (Reverse)
position, the reversing sensor system will operate even if
corner sensor operation was stopped by pushing the
“SONAR” switch.
• Setting when towbar is equipped
When reversing sensor system operation was stopped by
pushing the “SONAR” switch, the reversing sensor sys-
tem will not operate until the engine has been stopped
even if the gearshift lever is moved to the “R” (Reverse)
position.
To resume reversing sensor system operation, push the
“SONAR” switch or stop and restart the engine, and
then move the gearshift lever to the “R” (Reverse) posi-
tion.
Warning for obstacles
If there is an obstacle behind the vehicle, a warning buzzer
sounds to indicate the distance between the vehicle and the
obstacle.
Corner sensor
Back sensor (vehicles without a towbar)
Vehicle to obstacle distance Warning sound cycle
Approx. 60 to 40 cm Intermittent
Approx. 40 to 25 cm Fast intermittent
Within approx. 25 cm Continuous
Vehicle to obstacle distance Warning sound cycle
Approx. 150 to 80 cm Intermittent
Approx. 80 to 40 cm Fast intermittent
Within approx. 40 cm Continuous
To Next Page
Loading...
