4-52
Starting and driving
4
Back sensor (vehicles with a towbar)
Changing the detection areas
E00615800045
The detection areas can be changed as follows:
Vehicles with a towbar
While the operation of the system is stopped at the “SONAR”
switch, push the “SONAR” switch approximately 3 seconds or
more, and release it. The buzzer sounds twice to indicate that
the detection area has been changed.
Vehicles without a towbar
While the operation of the system is stopped at the “SONAR”
switch, push the “SONAR” switch approximately 3 seconds or
more, and release it. The buzzer sounds once to indicate that
the detection area has been changed.
OTE
● The detection area will not change if you keep the
“SONAR” switch pushed for 10 seconds or more.
Reversing sensor system operation indicator
lamp
E00615900088
In case there is a malfunction in the reversing sensor system,
the reversing sensor system operation indicator lamp will blink
and the warning buzzer will sound for approximately 5 sec-
onds. Even after the buzzer has stopped sounding, the indicator
lamp will continue blinking until the system reverts to the nor-
mal state. Have the vehicle inspected at a MITSUBISHI
MOTORS Authorised Service Point.
Vehicle to obstacle distance Warning sound cycle
Approx. 150 to 100 cm Intermittent
Approx. 100 to 60 cm Fast intermittent
Within approx. 60 cm Continuous
CAUTION
!
● The distances given are to be used for reference only,
as errors may be caused by various factors, such as
temperature, humidity, or the shape of the obstacles.
To Next Page
Loading...
Need help?
General
