OTE
● When the mode selection dial or the blower speed selec-
tion dial is set to the “AUTO” position again after manual
operation, the air selection dial will also be automatically
controlled.
Customising the air selection (Changing function
settings)
E00725800010
Functions can be changed as desired, as stated below.
● Enable automatic air control:
If the mode selection dial or blower speed selection dial is
turned to the “AUTO” position, the air selection switch is
also controlled automatically.
● Disable automatic air control:
Even if the mode selection dial or blower speed selection
dial is turned to the “AUTO” position, the air selection
switch is not controlled automatically.
● Setting change method
Hold down the air selection switch for about 10 seconds
or more.
When the setting is changed, a sound is emitted and the
indicator lamp flashes.
• When the setting is changed from enable to disable
3 sounds are emitted and the indicator lamp flashes 3
times.
• When the setting is changed from disable to enable
2 sounds are emitted and the indicator lamp flashes 3
times.
OTE
● The factory setting is “Enable automatic air control.”
● When the mode selection dial is turned to “ ”, in order
to prevent misting of the windows the ventilator automati-
cally switches to outside air even if “Disable automatic air
control” is set.
CAUTION
!
● Normally, use the outside position to keep the wind-
screen and side windows clear and quickly remove
fog or frost from the windscreen.
If high cooling performance is desired, or if the out-
side air is dusty or otherwise contaminated use the
recirculation position. Switch to the outside position
periodically to increase ventilation so that the win-
dows do not become fogged up.
● Use of the recirculation position for extended time
may cause the windows to fog up.
To Next Page
Loading...
