EasyManua.ls Logo

Mitsubishi Outlander 2017 - Page 158

Mitsubishi Outlander 2017
521 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Continuously variable transmission (CVT) (if so equipped)
Features and controls 5-77
5
3. Insert a screwdriver with a cloth over its
tip into the notch (A) of the cover. Pry
gently as shown to remove the cover.
4. Depress the brake pedal with the right
foot.
5. Insert a screwdriver in the shift-lock
release hole (B). Shift the selector lever to
the “N” (NEUTRAL) position while
pressing the screwdriver down.
N00560401088
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the selector lever position is shown on
the multi-information display.
N00582900031
If the ambient temperature is low, the selector
lever position display on the multi informa-
tion display may blink when the selector
lever is placed in the “D” (DRIVE), “Ds”
(DOWNSHIFT & SPORTY DRIVING), “L”
(LOW) or “R” (REVERSE) position immedi-
ately after the engine has been started. This
indicates that the transmission requires warm-
ing up. While the display is blinking, the
vehicle will not move, because the transmis-
sion keeps disengaging until the warm up is
completed even if the selector lever is placed
in the “D”, “Ds”, “L” or “R” position.
When the selector lever position display is
blinking, perform the following procedure:
1. Depress the brake pedal with your right
foot and place the selector lever in the
“N” (NEUTRAL) position for several
seconds.
2. Keep depressing the brake pedal and then
place the selector lever in the “D”
(DRIVE), “Ds” (DOWNSHIFT &
SPORTY DRIVING), “L” (LOW) or “R”
(REVERSE) position. If the selector lever
position display stops blinking, the warm
up is completed and the transmission will
function normally.
3. If the display is still blinking, repeat steps
1 and 2 above.
Selector lever position display
When the selector lever position
display blinks
WARNING
To avoid unintended vehicle movement,
keep brake pedal applied with your right
foot and do not depress the accelerator
pedal, while the selector lever position dis-
play is blinking.
BK0239700US.book 77 ペー 2016年6月16日 木曜日 午前10時58分

Table of Contents

Related product manuals