Continuously variable transmission (CVT) (if so equipped)
5-78 Features and controls
N00560501089
[For vehicles equipped mono-color liquid
crystal display meter]
When the selector lever position indicator
blinks while you are driving, there could be a
malfunction in the automatic transmission
system or CVT fluid temperature becomes
abnormally high.
[For vehicles equipped with color liquid
crystal display meter]
or
When the warning display or the warn-
ing display appears on the information screen
in the multi-information display while you
are driving, there could be a malfunction in
the CVT.
While the selector lever position display is
blinking, a buzzer will sound intermittently.
Warning display
The “A” indicator on the selector lever posi-
tion display will only blink if there is a prob-
lem with the CVT position switch.
It is not seen during normal driving.
If a malfunction occurs in the CVT while
driving, the indicator will blink.
In this case, immediately park your vehicle
in a safe place and follow these procedures:
[If the indicator blinks rapidly (once per sec-
ond), the CVT fluid is overheating.]
Park your vehicle in a safe place but do not
turn off the engine. Move the selector lever
to the “P” (PARK) position and open the
bonnet. Keep the engine, idling.
After a while, move the selector lever into
any position other than “P” (PARK) position
and confirm that the indicator stops blinking.
It is safe to continue driving if the indicator
no longer blinks.
If the indicator continues blinking or blinks
intermittently, have your vehicle inspected
by an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
[If the indicator blinks slowly (once per 2
seconds), the CVT safety device may be
operating due to a malfunction.]
Have the vehicle inspected by an authorized
Mitsubishi Motors dealer or a repair facility
of your choice immediately.
If a malfunction occurs in the CVT while
driving, the warning display or the
warning display will appear on the informa-
tion screen in the multi-information display.
In this case, follow these procedures:
[When warning display is showing]
The continuously variable transmission
(CVT) fluid is overheating. The engine con-
trol may activate to lower the CVT fluid tem-
perature, causing the engine revolutions and
vehicle speed to decrease, In this case, take
one of the following procedures.
• Slow down your vehicle.
• Stop your vehicle in a safe place, put the
selector lever in the “P” (PARK) position,
and open the engine hood with the engine
running to allow the engine to cool down.
BK0239700US.book 78 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
