Mitsubishi Outlander 2017 - Page 206

Forward Collision Mitigation System (FCM) (if so equipped)
Features and controls 5-125
5
N00593400036
The sensor (A) is located inside the wind-
shield as shown in the illustration.
The sensor is shared in the following sys-
tems:
 FCM
 Lane Departure Warning (LDW)
 Automatic high beam system
NOTE
 If the sensor or its surrounding area becomes
extremely high temperature when parking
the vehicle under a blazing sun, the “FCM
SERVICE REQUIRED” message may
appear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the engine,
please contact an authorized Mitsubishi
Motors dealer.
Handling of the sensor
CAUTION
 To maintain proper performance of the FCM,
LDW and Automatic high beam system;
• Always keep clean the windshield.
If the inside of the windshield where the
sensor is installed becomes dirty or fogged,
contact an authorized Mitsubishi Motors
dealer.
• Do not apply an impact or load on the sen-
sor or its surrounding area.
• Do not put anything including a sticker or
film on the windshield in front of or sur-
rounding the area of the sensor.
• Do not attempt to detach or disassemble the
sensor.
• If the windshield is misted, remove the mist
from the windshield by using the defogger
switch.
• Maintain the wiper blades in good condi-
tion. Refer to “Wiper blades” on page 9-44.
When replacing the wiper blades, use only
Mitsubishi Motors Genuine parts or equiva-
lent.
• Do not dirty or damage the sensor.
• Do not spray glass cleaner on the sensor.
Also, do not spill liquid, such as a bever-
age, to the sensor.
• Do not install an electronic device, such as
antenna, or a device that emits strong elec-
tric waves, near the sensor.
• Always use tires of the same size, same
type and same brand, and which have no
significant wear differences.
• Do not modify the vehicle’s suspensions.
CAUTION
BK0239700US.book 125 ページ ２０１６年６月１６日 木曜日 午前１０時５８分