Combination headlights and dimmer switch
Features and controls 5-227
N00593800027
If a problem occurs with the system, the fol-
lowing warning display will appear to the
type of the problem.
If a failure is detected in the system, the fol-
lowing warning display will appear and the
automatic high beam system will automati-
cally be turned off.
If the warning display remains even after the
ignition switch is turned to the “OFF” or
“LOCK” position or the operation mode is
put in OFF and then turned back to ON,
please contact an authorized Mitsubishi
Motors dealer.
[When the automatic high beam system is
malfunctioning]
[When the sensor is malfunctioning]
If the system becomes temporarily unavail-
able due to the high or low temperature of the
sensor, the following warning display will
appear.
After the temperature of the sensor has been
in range, the system will automatically return
to operation.
If the warning display does not disappear
after waiting for a while, there is a possibility
that the automatic high beam system has a
malfunction. Contact an authorized Mitsubi-
shi Motors dealer for inspection of the sys-
tem.
System problem warning
The automatic high beam system
deactivation due to fault
If the sensor or its surrounding area becomes
extremely high temperature when parking
the vehicle under a blazing sun, the “AHB
SERVICE REQUIRED” warning display
may appear.
If the message remains even after the tem-
perature of the sensor or its surrounding area
has been in range, please contact an autho-
rized Mitsubishi Motors dealer.
Sensor is too hot or cold
BK0239700US.book 227 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
