Mitsubishi Outlander 2017 - Page 309

Combination headlights and dimmer switch
5-228 Features and controls
5
If the automatic high beam system determines
that its performance has been degraded, the
warning display will appear.
This can occur when
 Foreign objects, such as dirt, snow or ice,
adhere to the windshield of the sensor
portion.
 In adverse weather conditions, such as
rain, snow, sand storms, etc.
 A front vehicle or an oncoming vehicle is
splashing water, snow or dirt.
When the sensor performance returns, the
automatic high beam system will resume
operation.
If the warning display does not disappear
after waiting for a while, there is a possibility
that the sensor has a malfunction. Contact an
authorized Mitsubishi Motors dealer for
inspection of the sensor.
N00563201234
This function turns on the front side-marker
and parking lights for about 30 seconds after
the UNLOCK button on the remote control
transmitter is pressed when the combination
headlights and dimmer switch is in the “OFF”
or “AUTO” position (vehicles equipped with
the automatic light control). The welcome
light function will operate only when it is
dark outside the vehicle.
N00547301178
This function turns on the headlights in the
low beam setting for about 30 seconds after
the ignition switch is turned to the “OFF” or
“LOCK” position or the operation mode is
put in OFF.
1. Turn the combination headlights and dim-
mer switch to the “OFF” or “AUTO”
position (vehicles equipped with the auto-
matic light control).
2. Turn the ignition switch to the “OFF” or
“LOCK” position or put the operation
mode in OFF. Also, if a key was used to
start the engine, remove the key from the
ignition switch.
 Windshield is dirty
Welcome light
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK button on the remote con-
trol transmitter.
• Turn the combination headlights and dim-
mer switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The headlights can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
For details, consult a Mitsubishi Motors
dealer.
On vehicles equipped with Mitsubishi Multi-
Communication System, screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for
details.
Coming home light
NOTE
BK0239700US.book 228 ページ ２０１６年６月１６日 木曜日 午前１０時５８分