HomeLink® Wireless Control System (if so equipped)
Features and controls 5-269
N00584700020
To program HomeLink
®
to operate a garage
door, gate, or entry door opener, home or
office lighting, you need to be at the same
location as the device.
1. Press the HomeLink
®
button that you
would like to program. The indicator light
(A) will flash orange slowly.
2. Position the end of your hand-held trans-
mitter (B) 1 to 3 inches (2 to 8 cm) away
from the HomeLink
®
button while keep-
ing the indicator light in view.
3. Press and hold the hand-held transmitter
button while watching the indicator light
(A). Continue pressing the button until the
indicator light (A) changes from slowly
flashing orange to either rapidly flashing
green (rolling code) or continuously lit
green (fixed code). Now you may release
the hand-held transmitter button.
4. Press the HomeLink
®
button that was just
programmed and observe the indicator
light.
• If the indicator light continuously illumi-
nates green, programming is complete
and your device should operate when the
HomeLink
®
button is pressed and
released.
• If the indicator light rapidly flashes
green, firmly press, hold for 2 seconds
and release the programmed HomeLink
®
button. Repeat the “press/hold/release”
sequence a second time, and, depending
on the brand of the garage door opener
(or other rolling code equipped device),
repeat this sequence a third time to com-
plete the programming process. At this
point if your device operates, program-
ming is complete.
Programming a new Home-
Link
®
You do not need to continue holding the
HomeLink
®
button.
If the indicator light does not flash, refer to
“Cleaning the programmed information” on
page 5-272.
Some hand-held transmitters may actually
train better from a distance of 6 to 12 inches
(15 to 20 cm). Keep this in mind if you have
difficulty with the programming process.
Some devices may require you to replace this
“Programming a new HomeLink
®
” step 3
with procedures noted in the “Gate operator /
Canadian programming” section. If the indi-
cator light does not change to rapidly flash-
ing green or continuously lit green after
performing these steps, contact HomeLink
®
at www.homelink.com
BK0239700US.book 269 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
