HomeLink® Wireless Control System (if so equipped)
5-270 Features and controls
• If the device does not operate, continue
with “Programming a new HomeLink
®
”
steps 5 to 7 to complete the program-
ming of a rolling code equipped device.
5. At the garage door opener receiver
(motor-head unit) in the garage, locate the
“Learn” or “Smart” button. This can usu-
ally be found where the hanging antenna
wire is attached to the motor-head unit
(see the garage door opener manual to
identify the “Learn” button.)
6. Firmly press and release the “Learn” or
“Smart” button. (The name and color of
the button may vary by manufacturer.)
There are typically 30 seconds to initiate
step 7.
7. Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed HomeLink
®
button. Repeat the
“press/hold/release” sequence a second
time, and, depending on the brand of the
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
HomeLink
®
should now activate your
rolling code equipped device.
N00584800021
Canadian radio-frequency laws require trans-
mitter signals to “time-out” (or quit) after
several seconds of transmission - which may
not be long enough for HomeLink
®
to pick
up the signal during programming. Similar to
this Canadian law, some U.S. gate operators
are designed to “time-out” in the same man-
ner.
The indicator LED on the hand-held transmit-
ter will go off when the device times out indi-
cating that it has finished transmitting.
If you live in Canada or you are having diffi-
culties programming a gate operator or
garage door opener by using the “Program-
ming” procedures, replace “Programming a
new HomeLink
®
” step 3 with the following:
3. Press and release - every 2 seconds
(“cycle”) your hand-held transmitter until the
HomeLink
®
indicator light changes from
slowly flashing orange to either rapidly flash-
ing green (rolling code) or continuously lit
green (fixed code). Now you may release the
hand-held transmitter button.
Proceed with “Programming a new Home-
Link
®
” step 4 to complete.
N00584900022
The HomeLink
®
has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Check your
garage door opener manual for the available
feature and HomeLink
®
compatibility. Also
for a listing of compatible systems contact
HomeLink
®
at: www.homelink.com
In the event that there are still programming
difficulties or questions, additional Home-
Link
®
information and programming videos
can be found online at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
Gate operator/Canadian pro-
gramming
If programming a garage door opener or gate
operator, it is advised to unplug the device
during the “cycling” process to prevent pos-
sible overheating.
Additional steps for program-
ming a door system with feed-
back
BK0239700US.book 270 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
