Dual-zone automatic climate control air conditioner
Comfort controls 7-7
N00737001448
Press or of the temperature control
switch to the desired temperature.
The selected temperature will be shown in the
display (A).
The above indicates the factory settings. You
can personalize the air selection switch and
air conditioning switch to match your per-
sonal preferences.
Contact your Mitsubishi Motors dealer or a
repair facility of your choice for assistance.
Refer to “Personalizing the air conditioning
switch (Changing the function setting)” on
page7-10.
Refer to “Personalizing the air selection
(Changing the function setting)” on page7-9.
The driver’s side and the passenger’s side
temperature can be controlled independently.
At this time, the “DUAL” indicator will be
shown in the display (A).
Temperature control switch
The temperature value of air conditioner is
switched in conjunction with outside temper-
ature display unit of the multi information
display.
On vehicles equipped with multi information
display - Type 1, refer to “Changing the tem-
perature unit” on page 5-180.
On vehicles equipped with multi information
display - Type 2, refer to “Changing the tem-
perature unit” on page 5-190.
When the engine coolant temperature is low,
the air temperature from the heater will be
cool/cold until the engine warms up, even if
you have selected warm air with the switch.
To prevent the windshield and windows from
fogging up, the vent mode will be changed to
“ ” and the blower speed will be reduced
while the system is operating in the AUTO
mode.
When you feel that it is hotter or colder than
the set temperature, you may adjust it to your
preference.
For further information, we recommend you
to consult an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
When the temperature is set to the highest or
the lowest setting, the air selection and the
air conditioner will be automatically changed
as follows.
Also, if the air selection is operated manually
after an automatic changeover, manual oper-
ation will be selected.
• Quick Heating (When the temperature is set
to the highest setting)
Outside air will be introduced and the air
conditioner will stop.
• Quick Cooling (When the temperature is set
to the lowest setting)
Inside air will be recirculated and the air
conditioner will operate.
Synchronized mode and dual mode
BK0239700US.book 7 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
