Mitsubishi PLK-E2010R - Mechanical Home Position Shifting (X & Y)

- 38 -
1) Turn the power switch ON and cancel the
sewing area limit with the operation panel.
a) For this cancellation, press the
MENU
key at
the normal mode condition, then MENU
MODE is appeared.
Press the
Program
key.
b) And press the
Area limit
key.
c) If you select [ALC]=[ON], the sewing area
limit control is canceled.
2) After the sewing area limit control is
canceled, press the
key and the
TOP
key. Window is back to the standard mode.
NOTE If do not cancel the sewing area limit, shifting the mechanical home position makes the effective
sewing narrower than the original.
(Example) If shift the mechanical home position to the X direction 60mm, the Y direction 25mm without
canceling the sewing area limit, the area covered with diagonal lines becomes invalid and the
effective sewing area becomes narrower as a bold rectangle shown on the figure.
60
100
25
50
100
200
50
100
2) After the cancellation of the sewing area limit, once, turn the power switch OFF.