6 - 14
6 INSPECTION AND MAINTENANCE
6.6.2 Troubleshooting of Motion controller
This section describes the contents of troubles for the error codes and corrective
actions of the troubles.
As for troubleshooting of PLC CPU area, refer to the QCPU User's Manual (Hardware
Design, Maintenance and Inspection) of their respective modules.
As for troubleshooting of I/O modules, refer to the "I/O Module Type Building Block
User's Manual" of their respective modules.
POINT
Check that the operating system software is installed before starting the Motion
controller.
To Next Page
Loading...
