4 - 13 4 - 13
MELSEC-Q
4 SETUP AND PROCEDURES BEFORE OPERATION
(2) Program examples
The program in the dotted area of (a) is common to (a), (b) and (c).
Is this example, the I/O signals for the Q64AD-GH are X/Y0 to X/YF
• Channel selection. ................................................................................. M0
• Offset setting .......................................................................................... M1
• Gain setting ............................................................................................ M2
• Channel change command ................................................................... M3
• Offset/gain setting value write command to the module ...................... M4
• Mode switching ...................................................................................... M5
• Channel designation storage device ..................................................... D0
• Dedicated instruction (G(P).OFFGAN) setting storage device ............ D1
To Next Page
Loading...
