7 - 3 7 - 3
MELSEC-Q
7 ONLINE MODULE CHANGE
7.2 Online Module Change Operations
The following gives the operations performed for an online module change.
CPU operation : Executed : Not executed
(User operation)
(Intelligent function module
operation)
X/Y
refresh
FROM/TO
instruction
1
Dedicated
instruction
Device
test
GX Configurator
Initial
setting
parameter
Monitor/
test
1: Access to the intelligent function module device (U \G ) is included.
2: In the absence of the operation marked 2, the operation of the intelligent function module is the operation performed prior to that.
3: With the input range set as shown below, online module change with a module that does not support the analog input range extended
mode causes an intelligent function module switch error.
For the Q64AD-GH: 4 to 20mA (Extended mode): A
H
1 to 5V (Extended mode): B
H
For the Q62AD-DGH: 4 to 20mA (Extended mode): A
H
To Next Page
Loading...
