3 - 54 3 - 54
MELSEC-Q
3 SPECIFICATIONS
3.4.5 Averaging process specification (buffer memory address 9: Un\G9)
(1) When selecting sampling processing or averaging processing, write the setting
to buffer memory address 9 (Un\G9).
(2) When you selected averaging processing, select the average time, average
count, move average or primary delay filter.
(3) To make the setting valid, the operating condition setting request (Y9) must be
turned ON/OFF. (Refer to Section 3.3.2.)
(4) By default, sampling processing is set for all channels.
b15 b12 b11 b8 b7 b4 b3 b0to to to to
CH4 CH3 CH2 CH1
For Q62AD-DGH, information of b8 to b15 is fixed at 0.
Processing method Setting value
Sampling processing 0H
Time averaging 1H
Count averaging 2H
Move averaging 3H
Primary delay filter 4H
[Setting example of Q64AD-GH]
When setting channel 1 for count averaging, channel 2 for time averaging,
channel 3 for primary delay filter, and channel 4 for sampling processing, store
412
H (1042) into the buffer memory address 9 (Un\G9).
b15
CH4 CH3 CH2 CH1
240
0412
H
(1042)
0000010000010010
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
1
[Setting example of Q62AD-DGH]
When setting channel 1 for time averaging, channel 2 for count averaging, store
0021
H (33) into the buffer memory address 9 (Un\G9).
b15
CH2 CH1
100
0021
H
(33)
00000 00001 00 1
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
2
000
To Next Page
Loading...
