2 - 1 2 - 1
MELSEC-Q
2 SYSTEM CONFIGURATION
2 SYSTEM CONFIGURATION
This chapter explains the system configuration of the A/D converter module.
2.1 Applicable Systems
This section describes the applicable systems.
(1) Applicable modules and base units, and No. of modules
(a) When mounted with a CPU module
For the applicable modules, the number of modules, and base units
applicable to the A/D converter module, refer to the user’s manual for the
CPU module used.
Note the following when the A/D converter module is mounted with a CPU
module.
• Depending on the combination with other modules or the number of
mounted modules, power supply capacity may be insufficient. Pay
attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of
modules.
• Mount a module within the number of I/O points for the CPU module. If
the number of slots is within the available range, the module can be
mounted on any slot.
REMARK
When the module is used with a C Controller module, refer to the user’s manual for
the C Controller module.
(b) Mounting to a MELSECNET/H remote I/O station
For the MELSECNET/H remote I/O station, the number of modules, and
base units applicable to the A/D converter module, refer to the Q
Corresponding MELSECNET/H Network System Reference Manual
(Remote I/O network).
(2) Support of the multiple CPU system
When using the A/D converter module in a multiple CPU system, refer to the
following manual first.
• QCPU User's Manual (Multiple CPU System)
2
To Next Page
Loading...
