4 - 20 4 - 20
MELSEC-Q
4 SETUP AND PROCEDURES BEFORE OPERATION
(b) When switching the mode using the setting of the mode switching setting
(buffer memory addresses 158, 159: Un\G158, Un\G159) and operation
condition setting request (Y9)
POINT
When running this program together with the normal-mode A/D conversion
program (shown in Section 6.4.2), use
1 of this program as the initial setting
program. Before using this program, check the device numbers.
Note) When adding this program to the normal-mode A/D conversion program
(shown in Section 6.4.2), replace the existing initial setting program with the
program marked with
1. Before using this program, check the device
numbers.
(c) When switching the mode by making intelligent function module switch setting
Only the common program is necessary.
To Next Page
Loading...
